6
www.jetgroupbrands.com
Single Phase
Refer to the wiring drawing inside the electrical box
and on page 5 for proper motor and transformer
connections, lead selection and wiring connections
from the motor to the power source for the voltage
you are using. Important: Immediately after wiring
the machine, remove the drive belt, turn on the
power and make sure the motor is running in the
right direction (counter-clockwise when looking at
the motor shaft.)
General Operating
Instructions
Removing and Installing the Blade
When your machine was shipped, a blade was
supplied and mounted on the saw. When selecting
a new blade refer to the selection of sawblades.
The machine requires a blade 1" x 0.032" x 119-1/2"
(27mm x 0.9mm x 3,035mm).
1. Disconnect the machine from the
power source.
2. Raise the saw frame about 6" and close the feed
control valve by turning it clockwise as far as it
will go. (Do not over tighten.)
3. Open both wheel covers and clean the chips out
of the machine.
4. a) Loosen the nut at the back of the left hand
wheel, (item A-1).
b) To release blade tension, turn the blade
tension hand wheel (item C, Fig. 1),
counter-clockwise.
5. Slide left blade guide arm to the right as far
as possible.
6. Remove the blade from both wheels and out of
each blade guide.
7. Make sure the teeth of the new blade are
pointing in the direction of travel. If necessary,
turn the blade inside out.
8. Mount the blade in place on the wheels
(A-1 and A-2) and through the upper
blade guard. (B) Fig.1.
9. Work the blade all the way up between the blade
guide bearings with the back of the blade against
the back-up bearing, as shown in Fig.2.
Fig. 1
Fig. 2
C
A1
B
A2
To Next Page
Loading...
