JetCat P400-PRO - Manual Advanced Section; Smoker Pump

M
Ingenieurbüro CAT, M. Zipperer GmbH +49-7634-5056-800
Wettelbrunner Straße 6 sales@jetcat.de
50
79282 Ballrechten-Dottingen www.jetcat.de
GERMANY
Instruction
m
anual JetCat
-
PRO engines
,
1.7
-
V12.01V
Manual advanced section
Smoker pump
The ECU can directly control a smoker pump for injection of smoke fluid (e.g. diesel oil) in the exhaust blast.
The function of the smoker pump can be defined in the “Limits menu”
(Parameter: „SmokerValve Ctrl“)
The possible option for the parameter „SmokerValve Ctrl” are:
Option Description
DISABLED The smoker pump/valve is not used,  always off!
Open if AuxSw=0 Smoke pump is activated if the AUX-Switch (3-Pos. switch) is brought into the
lower position (“OFF”-Position) and the engine is running.
To be able to use this function it is necessary, that the AUX-channel is
activated, this is the parameter „AUX-channel func“ (see below) must not be
adj
usted to „NOT USED“.
Open if AuxSw=2 Smoke pump is activated if the AUX-Switch (3-Pos. switch) is brought into the
upper position (“AUTO-OFF”-Position) and the engine is running.
To be able to use this function it is necessary, that the AUX-channel is
activated, this is the parameter „AUX-channel func“ (see below) must not be
adjusted to „NOT USED“.
Attention!
Inject the smoke fluid rear the thrust tube to avoid flash fire of unburned fuel.
A one way valve inserted downstream of the smoker pump can help to avoid leaking of smoke fluid
when the smoke pump is not running.