To Next Page

To Previous Page

1.11 Inlating the Tires

CAUTION: BEFORE INFLATING EACH TIRE, MAKE SURE THAT IT IS EVENLY ALIGNED AROUND BOTH SIDES OF THE ENTIRE RIM.

1. REMOVE THE VALVE DUST CAP FROM THE TIRE VALVE.

2. CONNECT THE AIR PUMP TO THE VALVE BY PRESSING THE NOZZLE STRAIGHT DOWN ONTO THE VALVE.

3. FLIP DOWN THE LOCKING LEVER ON THE NOZZLE.

4. USE EVEN STROKES WHEN PUMPING AIR INTO THE TIRE.

5. MONITOR THE GAUGE ON THE PUMP.

6. STOP WHEN YOU'VE REACHED THE RECOMMENDED PSI OF 3545 FOR THE TIRE*.

7. UNLOCK THE NOZZLE, REMOVE IT FROM THE VALVE, AND REPLACE THE DUST CAP.

8. REPEAT FOR THE OTHER TIRE.

* DO NOT OVERINFLATE TIRES. STAY WITHIN THE RECOMMENDED PSI RANGE.

VALVE DUST CAP

TIRE PUMP

NOZZLELOCKING LEVER

Jetson Haze Guide

Other manuals for Jetson Haze