2. LOOSEN BUT DO NOT REMOVE THE 2 AXLE NUTS ON THE FRONT WHEEL BY TURNING THEM COUNTERCLOCKWISE WITH
YOUR FINGERS OR THE 15MM WRENCH. DEPENDING ON HOW TIGHTLY THEY ARE FASTENED, YOU MAY NEED TO USE AN
ADDITIONAL 15MM WRENCH TO HOLD THE NUT ON ONE SIDE STEADY SO THAT YOU CAN LOOSEN THE OTHER.
3. PUSH AND HOLD THE WASHERS NEXT TO THE NUTS OUTWARD SO THAT THEY ARE TOUCHING THE NUTS, LEAVING A
SPACE ON THE AXLE BETWEEN THE WASHERS AND THE COMPONENTS IN THE CENTER OF THE WHEEL.
AXLE NUT
AXLE NUT
WASHER
15MM WRENCH
FRONT WHEEL
To Next Page
Loading...
Need help?
General
