YOU WILL NEED THE PHILLIPS-HEAD SCREWDRIVER AND THE 10MM WRENCH.
1. USE THE SCREWDRIVER TO HOLD THE BOLT ON THE FRONTSIDE OF THE
FRONT FORK STEADY WHILE YOU LOOSEN AND REMOVE THE NUT ON THE
BACKSIDE OF THE FORK BY TURNING IT COUNTERCLOCKWISE WITH THE
10MM WRENCH.
2. REMOVE THE WASHER FROM THE END OF THE BOLT, THEN REMOVE THE
BOLT. SET THE WASHER, BOLT, AND NUT ASIDE.
1.6 Attaching the Front Fender
10MM WRENCH
WASHER
NUT
BOLT
PHILLIPSHEAD SCREWDRIVER
To Next Page
Loading...
Need help?
General
