5. ON EACH SIDE OF THE AXLE, ROTATE THE WASHER UNTIL THE WASHER HOOK IS ALIGNED WITH THE WASHER HOOK
HOLE IN THE FRONT FORK. PUSH THE HOOK INTO THE HOLE.
6. FULLY TIGHTEN BOTH AXLE NUTS BY TURNING EACH CLOCKWISE WITH THE 15MM WRENCH.
7. CHECK THAT THE FRONT WHEEL IS SECURED TO THE FORK.
IMPORTANT: AN UNSECURED WHEEL CAN LOOSEN OR FALL OFF, PUTTING THE RIDER AT RISK OF SERIOUS INJURY. ENSURE
THAT THE WHEEL IS SECURELY FASTENED TO THE FRONT FORK.
15MM WRENCH
FRONT FORK
WASHER HOOK HOLE
WASHER HOOK
To Next Page
Loading...
Need help?
General
