7 PANIC BY REMOTE CONTROL
Press and hold button 3 of the remote control for 4 seconds. The PGM relay triggers for 6
seconds, then deactivates.
Obs.: - Button 3 of the remote control must be programmed.
- The PGM must be programmed to work along with the SIR out.
8 PROGRAMMING MODE
With the central unit disarmed, press and hold the programar button until the programar LED
turns off. Release the program button and the LED starts flashing, signaling the programming
mode. To exit, press and hold the programar button until the LED stops flashing.
9 AUTOMATIC REARMING AFTER DISARMING
This function enables the automatic arming of the central unit 45 seconds after the disarming in
case there is no violation of an enabled sector. This resource avoids random disarming due to
accidental touching of the remote control buttons or even children playing with the remote. To
program, follow the instructions below:
With the central unit in the programming mode, press and hold button 1 of the remote control
for 4 seconds. Two beeps of the siren indicate the rearming is enabled, while 1 beep of the siren
indicates the automatic rearming is disabled.
Obs.: - Button 1 of the remote control must be programmed.
- There is no automatic rearming if the central is disarmed when the siren is ringing.
10 PROGRAMMING OF THE ARM AND DISARM BEEP
This function allows the central unit to issue beeps of the siren when arming and disarming. To
program, follow the instruction below:
With the central unit in the programming mode, press and hold button 2 of the remote control
for 4 seconds. Two beeps of the siren indicate that the arm/disarm beep is enabled, while 1
beep of the siren indicates that the beep is disabled.
Obs.: - Button 2 of the remote control must be programmed.
11 PROGRAMMING OF THE SIREN TRIGGER TIME
With the central unit in the programming mode, press and hold button 3 of the remote control
for 4 seconds. One beep of the siren indicates a trigger time of 1 minute, while 2 beeps of the
siren indicate a trigger time of 5 minutes (Default).
Obs.: - Button 3 of the remote control must be programmed.
- By accessing the Cloud line programmer software, it is possible to change the time from
1 to 255 minutes.
7
To Next Page
Loading...