To Next PageTo Next Page
Need help?Do you have a question about the JL Audio 250/1v2 and is the answer not in the manual?
General| THD at Rated Power | < 0.05% |
|---|---|
| Crossover Type | Low-pass |
| Power Output (RMS) | 250 watts x 1 @ 4 ohms |
| Input Sensitivity | 200 mV - 4 V |
| Fuse Rating | 30 A |
| Crossover Frequency Range | 50 Hz - 200 Hz |
| Bass Boost | 0 to +12 dB @ 45 Hz |
Guidance on optimal amplifier mounting for heat dissipation and safety precautions during installation.
Steps for installing the amplifier, connecting power, and understanding fuse requirements.
How to use a +12V remote turn-on lead to control the amplifier's power state.
Using audio signal presence to automatically turn the amplifier on and off.
Warnings about signal sensing limitations and using turn-on output for other devices.
How to connect audio sources and explanation of switchable input voltage ranges.
How to use the Input Sens. control to match source unit output for optimal clean output.
Details on the variable low-pass filter, its slope selection, and defeat option.
Description of the infrasonic filter and LF boost features.
Details on R.I.P.S. power supply, impedance handling, and warnings about loads.
How to connect speakers and a crucial warning against bridging amplifiers.
Explanation of the Power (Green), Thermal (Red), and Low Ω (Amber) indicator lights.
Instructions on how to obtain service and a warning against self-repair.
A step-by-step guide to correctly setting the amplifier's input sensitivity with necessary equipment.
Steps to diagnose and resolve common amplifier problems like no power, distortion, or no output.
Details of the limited warranty terms, coverage, and exclusions for the amplifier.
Instructions on how to send the product for service and contact information for inquiries.
Information regarding warranties for products purchased outside the United States.
