JLG DSP S - User Manual

To Next Page

Operation and Safety Manual

Original Instructions - Keep this manual with the machine at all times.

Models- DSP S

- DSP

i-S

- DSP M

- DSP

i-M

- DSP L

P/N - 31210284

March 21, 2022 - Rev E

English - Operation & Safety

Main Page

Table of Contents7
Section - Paragraph, Subject Page Section - Paragraph, Subject Page12
Section 1 - Safety Precautions13
General13
Pre-Operation13
Operator Training and Knowledge13
Workplace Inspection14
Machine Inspection14
Operation15
General15
Trip and Fall Hazards15
Electrocution Hazards16
Tipping Hazards17
Minimum Approach Distances (M.A.D.)17
Crushing and Collision Hazards19
Lifting and Hauling20
General20
Section 2 - Preparation and Inspection21
Personnel Training21
Operator Training21
Training Supervision22
Operator Responsibility22
Preparation, Inspection, and Maintenance22
Inspection and Maintenance Table23
Pre-Start Inspection24
Daily Walk-Around Inspection24
Daily Walk-Around Inspection25
Walk-Around Inspection Components26
Function Check27
Function Check Items27
Section 3 - Machine Operation29
General29
Machine Description29
Machine Operating Component Locations30
Ground Control Station - Operation31
Ground Control Station31
General32
Control Station Selector Switch32
Emergency Stop/Shut down Button33
Brake Release Button34
Platform Lift Controls34
Platform Control Station - Operation35
Platform Control Console35
General36
Platform On/Off Key Switch36
Emergency Stop Button37
Horn Button37
Platform Control Display Unit38
Variable Message Zone39
Battery State of Charge Indication42
Battery Low Voltage Warning Indicators42
Function Key and Menus43
Programming Platform Height Limitation44
Immobilizer (if Configured)45
Controls Handles47
Drive Joystick48
Steering Joystick48
Platform Lift Controls49
Tray Lift Control (if Equipped)49
Grade and Side Slope49
Handles Position Setting50
Platform Manual Descent Control Valve51
Activating the Internal Manual Descent Valve51
Internal Manual Descent Valve Location51
Tray Adjustment52
Manual Tray Height Adjustment52
Powered Tray Height Adjustment52
Parking Machine53
Battery Charging54
Charger Interface55
Transporting, Lifting and Tie-Down Proce56
Dures56
General56
Forklift Truck Transport56
Forklift Truck Lifting Pockets56
Vehicle Transport Using the Tie-Down Lift Lugs57
Front and Rear Tie-Down Lift Lugs58
3.10 Decal Installation59
Decal Installation61
Section 4 - Emergency Procedures63
General Information63
Emergency Operation63
Operator Unable to Control Machine63
Platform Caught Overhead63
Incident Notification63
Section 5. Accessories65
Material Handling Tray - Cargo Strap65
Caster Wheel Guard65
Extinguisher Location66
Material Handling Tray - Quick Release (Powered Tray Option Only)67
Panel Carrier67
Parcel Guard69
Installation69
Removal69
Section 6. General Specifications and Operator Maintenance71
6.1 Introduction71
6.2 General Specifications72
Machine Specifications72
Drive Speeds74
Fluid Capacities74
Wheels Specs74
Electrical Specifications74
Electric Power Unit75
6.3 Operator Maintenance76
Lubrication76
Hydraulic Oil Specifications - Standard76
Hydraulic Oil Specifications - Optional77
Oil Level78
Hydraulic Oil Check78
Ball Screw (Powered Tray Option Only)79
6.4 Battery Maintenance80
Battery Replacement80
Battery Charger Troubleshooting85
6.5 Tires and Wheels89
Tire Wear and Damage89
Wheel and Tire Replacement89
Wheels Installation90
Wheel Torque Chart91
Wheel Bolt Tightening Sequence91
Supplemental Information Only Applicable to Ce / Ukca Machines92
Diagnostic Trouble Codes (Dtc)93
Introduction93
Mast Sensor Default Code93
Operator Presence Detection (Enable)94
6.8 Ec Declaration of Conformity95
6.9 Ukca Declaration of Conformity96
Section 7. Inspection and Repair Log97
Inspection and Repair Log97

JLG DSP S - User Manual

Table of Contents

JLG DSP S Specifications

Related product manuals

Brand	JLG
Model	DSP S
Category	Lifting Systems
Language	English