EasyManua.ls Logo

JMB VL-3E-1 Evolution - Normal Procedures; Before Entering Cockpit; After Entering Cockpit; Before Engine Starting and Starting of Engine

JMB VL-3E-1 Evolution
39 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
VL-3E-1 Pilot Operating Handbook
date of issue:
22/39
4.3 Normal procedures
4.3.1 Before entering cockpit
1. Aeroplane surface - check of covers and caps
2. Cockpit - items inside the cockpit
3. Ignition - off
4. Master switch - off
4.3.2 After entering cockpit
1. Rudder control - free movement check
2. Brakes - check of function
3. Hand control - free movement check
4. Trim - check control movement
5. Flaps - check of function
6. Undercarridge - down
7. Engine controls - throttle and choke lever movement
8. Fuel valve - off
9. Fuel gauge - fuel quantity check
10. Switch box - off
11. Circuit breakers - off
12. Ignition - off
13. Instruments, COMM- condition check
14. Safety harness - check of integrity and attachment
15. Cockpit - condition and canopy lock function
4.3.3 Before engine starting and starting of engine
1. Fuel valve - on
2. Switch box - turn the key
3. Circuit breakers - on
4. Propeller - minimum propeller pitch
5. Throttle - set for idling
6. Choke - according to engine temperature
7. Control stick - fully pulled
8. Check free area - clear
9. Master switch - on
10. Ignition box - on (both circuit) by turning the key in two steps to the right
11. Brakes - fully applied
12. Start - by turning the key to the right, untill the engine start and then release
pressure on the key
13. After starting - set throttle to idling
14. Oil pressure - within 10 sec. min. pressure
15. Choke - off
16. Engine warm - according to 4.3.4

Table of Contents