If you cannot seat the cog fully, by hand, use this procedure. Seat the cog as far
as you can by hand. Place a flat piece of wood, on top of the cog. Rap the board
smartly (centered over the cog) with a hammer. Repeat as necessary until the cog
is fully seated.
If the cog comes off the lid during processing, it was not completely seated. Re-
seat the cog.
The cog has a small (1 1/2" or 35 mm) red ring that functions as a washer and
seal between the lid and lift. It is located just inside the gear ring. This ring will
wear with long, heavy use, and may need replacement. If you find the washer is staying on the lift
when you remove the tank or drum, replace it. The cog lid washer's part number is #07095. The
tank lids that come with the ATL-1000 processor do not have a washer installed in the lid. If you
wish to use one of these lids, be sure to place a washer in the lid. If you use a lid without a washer,
the junction of the JOBO Lift and tank will leak.
Never try to remove an installed cog from its lid, as you will break either the cog or the lid.
Back to Top
To Next Page
Loading...
Need help?
General
