> Home D
> Home GB
> Service
> Back
| E-Mail Formular | Webmaster | Impressum | ©JOBO AG
Service Analog
Instructions for Loading the #3027 and #3028
Sheet-Film Drums
ΠThe drum and insert must be completely dry before attempting to load the
film in the insert.
� Remove the drum insert from the drum body and place on a clean, dry,
even surface.
Ž Load the sheet film emulsion side up in the insert, making sure every edge
is seated under every ‘pin’ (see graphic below) on either side and one end.
When the insert is rolled up, the film should seat itself under the pins at the
other end
To Next Page
Loading...
