Jofemar TAOS BASIC - Power Consumption and Maintenance; Power Consumption and Assigned Power; Maintenance and Cleaning Procedures

TAOS Serie
MNP143ENV05 Date: 2018/02/21 Rev. 02 9 of 12
8. Power consumption and assigned power
POWER CONSUMPTION (kw∙h)
ModeL
Standby 24h
BASIC
0.5
SLIM
0.5
TOUCH 10”
(Not available)
Procedure used
UNE-EN-50597
Model
ASSIGNED POWER (w)
BASIC
30
SLIM
30
TOUCH 10”
(Not available)
9. Maintenance cleaning
Note: always clean when the machine is disconnected
• It is very important never to touch those areas powered at 220 V, such as the ballast box, the
power box and live cables. To access areas where there are components powered at 220 V, open
the machine’s outside door and use a “Torx” screw driver to remove the metal boxes protecting
these components.
• To clean the exterior of the machine, use a moist cloth with warm water and dry with a soft cloth.
• Rub gently the screen with a soft cloth and only in one direction to avoid scratches.
• Use specific cleaners, applying them on a clean cloth. Don’t apply directly the cleaner on the
screen, because it can filter to the interior and produce damages. Don’t use alcohol, solvents or
other abrasive cleaner.
• It is recommended to clean periodically
the walls and ramps of the selector,
where the coins circulate with a soft
bristle brush and a rag or moist cloth.