27
9. Press one key on the corresponding division and hold the key. The
display will now show following Key: the key indicator and following
Vol: the volume.
10. Use the - and + pistons to set the desired volume.
11. Press the SET piston to save the change.
12. The display requests confirmation. Use the - and + pistons to select No
or Yes.
13. Press the SET piston for confirmation.
14. Press the MENU piston to return to the main menu.
15. If the changes have not been saved, the display will show Discard
changes?. Use the - and + pistons for Yes and press the SET piston to
cancel the changes.
16. Press the MENU piston twice to exit the Easy Menu.
More key volumes can be changed by pressing another key or by
selecting another stop.
Reset one stop
The Reset one stop function resets the key volumes for one stop in one
intonation to the factory setting.
1. Switch off all stops.
2. Select an intonation.
3. Press the MENU piston.
4. Use the - and + pistons to select the Key Volumes function on the
display.
5. Press the SET piston.
6. Use the - and + pistons to select the Reset one stop function on
the display.
7. Press the SET piston.
8. Activate one stop.
9. The display requests confirmation. Use the - and + pistons to select No
or Yes.
10. Press the SET piston.
11. Press the MENU piston twice to exit the Easy Menu.
Reset ALL stops
The Reset ALL stops function resets the key volumes of all stops in one
intonation to the factory setting.
1. Select an intonation.
2. Press the MENU piston.
3. Use the - and + pistons to select the Key Volumes function on the
display.
4. Press the SET piston.
5. Use the - and + pistons to select the Reset ALL stops function on the
display.
6. Press the SET piston.
7. The display requests confirmation. Use the - and + pistons to select No
or Yes.
8. Press the SET piston for confirmation.
9. Press the MENU piston twice to exit the Easy Menu.
To Next Page
Loading...
Need help?
General
