FANs 121, 1628.3, 268.1
Technical Bulletin EDA-2040
Issue Date 0196
© 1996 Johnson Controls, Inc.
1
Part No. 34-619-18, Rev. E
Code No. LIT-121342
I
nstallation
The actuator is not position sensitive and can be
mounted in any convenient orientation. Wiring
terminals must be accessible and protected from
moisture and corrosive fumes. No extra mounting
brackets, linkage, or couplers are required for
standard mounting.
Note: The standard length shaft coupler must be
used when the EDA-2040 or ATP-2040 is
used with an EDA-2040-102 Switch Kit.
K
it Includes
●
actuator
●
No. 10 thread cutting tapping screw
●
position scale
●
position indicator
●
CBL-2000 Wiring Harness (six female quick
connects with attached cables) for ATP-2040
Note: The CBL-2000 can also be ordered
separately.
T
ools Required
●
screwdrivers, flat-blade (or nut driver) 5/16 in.
and No. 2 Phillips
●
Allen wrench (90 degree hex key), 1/8 and
9/64 in. short series
●
pliers
●
drill, 5/32 in. (4 mm) drill bit
●
screwdriver, No. 2 Phillips
●
continuity tester (visual, audio, or DVM)
!
CAUTION:
Equipment Damage Hazard.
Disconnect all power supplies
before wiring and follow the
National Electrical Code and all
local regulations to avoid
possible electrical shock or
damage to the equipment.
EDA-2040/ATP-2040 Electric Damper Actuator Installation
To Next Page
Need help?
General
