22 FX20/60 Supervisory Controllers Installation Instructions
10. Reconnect any Ethernet, serial, modem, and I/O
connectors to the FX20/FX60 and any installed
accessory modules.
11. If using NDIO modules, and if any of your I/O
points have voltage, turn on the devices or
reconnect power to them.
12. Restore power to the FX20/FX60. To verify
operation, see Checking the Status LEDs.
13. Use FX Workbench to recommission the
FX20/FX60 and install the saved station
database.
Building Efficiency
507 E. Michigan Street, Milwaukee, WI 53202
Johnson Controls® is a registered trademark of Johnson Controls, Inc.
All other marks herein are the marks of their respective owners. © 2014 Johnson Controls, Inc.
To Previous Page
Loading...
