EasyManua.ls Logo

Johnson Controls FireClass FC718D - User Manual

Johnson Controls FireClass FC718D
49 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Installation Guide
120.515.867_FC-FC700-P-I
Doc. version 2.0
10. December 2020
FireClass
FC700 Series
Panels

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the Johnson Controls FireClass FC718D and is the answer not in the manual?

Johnson Controls FireClass FC718D Specifications

General IconGeneral
BrandJohnson Controls
ModelFireClass FC718D
CategoryFire Alarms
LanguageEnglish

Summary

FireClass FC700 Series Panel Installation

Installation Notes and Safety Warnings

Critical Safety Warnings

Highlights dangers of high voltage and essential earthing requirements.

FC702;708;718 Panel Overview

Mounting FC702;708;718 Panels to Wall

Step-by-step guide for securely mounting the panel to a wall.

Connecting Mains Cable and Protective Earth

Details safe connection of mains power and protective earth for the panel.

Installing Fire Detection Loops

Run and Temporarily Connect Loops

Guide to running loop wiring and making temporary connections for testing.

Perform Loop Insulation Checks

Instructions for performing essential insulation resistance tests on loops.

Wire Remaining Modules and Measure Loop Resistance

Connect modules and measure loop resistance values for recording.

Battery Installation

Install FC700 Series Batteries

Specific steps for installing batteries in FC700 series control panels.

Mounting Repeater Panels

Connecting Repeaters

Install the FC-FI Field Interface Board

Configure FC-FI Switches and Jumpers

Details FC-FI board switches, jumper positions, and DIP settings.

Change Fuses on FC-FI Board

Instructions for safely replacing user-changeable fuses on the FC-FI board.

Install Optional Cards and Modules

Install PLX800 Loop Expansion Card

Step-by-step guide to installing the PLX800 loop expansion card.

PLX800 Loop Expansion Card Details

Install PN1800 Network Interface Card

PN1800 Network Interface Card Configuration

Details settings for baud rate, topology, host interface, and emergency display.

Change Fuse on PN1800 Network Interface Card

Install IOB800 and FB800 Boards

Install CCU3 and MOXA Modules

Install FCZ4 x or FCZ8 x Zonal Indicators

FC1 DS Graphical User Interface (GUI) Details

Related product manuals