When enabled the system can detect when an unusual amount of RF signals are being
transmitted in the PowerG spectrum leading to a potential loss of connectivity. This event
reports to the central station when enabled. Choose from Disabled, UL20/20 or En
30/60.
When enabled the system can detect when an unusual amount of RF signals are being
transmitted on the frequency of the legacy daughter card installed in the panel
(319.5MHz, 345MHz or 433MHz) leading to a potential loss of connectivity. This event
reports to the central station when enabled.
Jam Detection Local Alarm
NOTE: Not evaluated by UL/cUL
When enabled the system will sound a local alarm. “Jam Detection” must be active for
this to function properly
SRF Jam Sensitivity Level
Choose between HIGH and NORMAL sensitivity levels
Allow Master Code to Access Security
Sensors
Allow the Master Code to access to the Security Sensor icon, including Auto Learn
Sensor, Add Sensor, Edit Sensor, Delete Sensor, Sensor Status & Sensor Group
Open/Close Reports Allowed For
Auto Learn
Rather than sending a tamper to auto learn a sensor, enabling this will allow an open/
close of the sensor to trigger auto learn
Panel Glass Break Detector
Creates an independent zone that leverages the panel’s built-in microphones to act as a
glass break detector. This will fall into the zone order at the time you enable this feature.
NOTE: This feature can not be Enabled if Panel Ambient Noise Detection is Enabled.
INSTALLER/DEALER SETTINGS
To Next Page
Loading...
