Creates an independent zone that leverages the panel’s built-in camera to act as an
activity motion detector. This will fall into the zone order at the time you enable this
feature. Motion can trip once every 4 minutes. NOTE: The panel motion detector is for activity
monitoring and automation only (Group 25) and will not create an alarm condition or act as a security PIR.
Panel Ambient Noise Detector
When Enabled, the Panel's built-in microphones can monitor for loud noise detection
above a settable dB threshold and generate an alert. Useful for MDU, apartments and
short term rentals where noise complaints are a concern. After an alert is generated, a 30
second cool down period is instituted. NOTE: This feature can not be Enabled if Panel Glass Break
Detector is Enabled.
Set the threshold at which the Panel Ambient Noise Detector determines there is enough
noise to generate an alert. Choose from values between 75 and 95 dB. NOTE: This setting is
greyed out and not selectable unless Panel Ambient Noise Detector is Enabled.
Determines the length of time for which the panel must detect noise above the threshold
level in order to generate a noise notification.
Determines whether the panel indicates locally on the screen that noise event has been
detected.
Home
Automation and
Security
Choose which type of Zigbee network you’d like to use. Options are Home Automation
and Security or Smart Energy. NOTE: This setting only appears when a Zigbee daughter card is installed in
the Panel.
QOLSYS CONFIDENTIAL AND PROPRIETARY
PAGE OF 37 178
INSTALLER/DEALER SETTINGS
To Next Page
Loading...
