When enabled, a screen lock page will appear. Screen lock restricts access to the panel based
on valid user codes. NOTE: This setting is automatically enabled when Partitions are enabled, though it can
subsequently be disabled if desired. It is also enabled for “EN Grade 2”
Require user code for arming the panel. NOTE: this option shall be enabled for UL/cUL and EN Grade 2
Refuse Arming When Battery
Low
Will not allow panel to arm if battery is low (below 8%). NOTE: This option shall be enabled for EN Grade 2
Toggle whether or not to bypass open or tampered sensors automatically. NOTE: Shall be disabled
for UL/cUL. This setting is turned off and greyed out when the “En Grade 2” setting is enabled.
When enabled, if Arm Away is selected at the panel then there is no timed exit delay. Instead,
the system is not fully armed until an Entry/Exit door is violated. NOTE: This setting is greyed out an
unavailable unless EN Grade 2 is enabled.
If panel is armed “Away” but a delay door is not opened, the panel assumes you are still home
and changes arming to “Stay” mode
Arm stay immediately with no countdown timer
Automatically extend countdown timer if delay door is opened during countdown process a
second time
QOLSYS CONFIDENTIAL AND PROPRIETARY
PAGE OF 43 198
To Next Page
Loading...