Table 23: MS-NIE551x-3 (Release 9.0 only)
Specification Description
Housing
Plastic housing with internal metal shield; material: ABS + polycarbonate;
Protection: IP20 (IEC 60529)
Mounting On flat surface with screws on four mounting feet or on dual 35 mm DIN rail
Dimensions(Height x Width
x Depth)
226 mm x 332 mm x 96.5 mm (8.9 in. x 13.1 in. x 3.8 in.) including mounting
feet
Minimum space for mounting: 303 mm x 408 mm x 148 mm (12.0 in. x 16.1 in.
x 5.8 in.)
Shipping Weight 2.9 kg (6.4 lb)
United States: UL Listed, File E107041, CCN PAZX, UL 916, Energy
Management Equipment, FCC Compliant to CFR47, Part 15, Subpart B, Class A
Canada: UL Listed, File E107041, CCN PAZX7, CAN/CSA C22.2 No. 205, Signal
Equipment, Industry Canada Compliant, ICES-003
Europe: CE Mark - Johnson Controls, Inc. declares that this product is in
compliance with the essential requirements and other relevant provisions of
the EMC Directive.
Australia and New Zealand: RCM Mark, Australia/NZ Emissions Compliant
Compliance
BACnet International: BTL 35-2004 Listed B-BC
The performance specifications are nominal and conform to acceptable industry standard. For application at
conditions beyond these specifications, consult the local Johnson Controls office. Johnson Controls shall not be
liable for damages resulting from misapplication or misuse of its products.
Single point of contact
APAC Europe NA/SA
JOHNSON CONTROLS
C/O CONTROLS PRODUCT
MANAGEMENT
NO. 32 CHANGJIJANG RD NEW
DISTRICT
WUXI JIANGSU PROVINCE 214028
CHINA
JOHNSON CONTROLS
WESTENDHOF 3
45143 ESSEN
GERMANY
JOHNSON CONTROLS
507 E MICHIGAN ST
MILWAUKEE WI 53202
USA
For more contact information, refer to
www.johnsoncontrols.com/locations.
North American emissions
compliance
United States
This equipment has been tested and found to
comply with the limits for a Class A digital device
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference when this equipment
is operated in a commercial environment. This
equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instruction manual, may cause
harmful interference to radio communications.
Operation of this equipment in a residential area
may cause harmful interference, in which case the
users will be required to correct the interference at
their own expense.
Canada
This Class (A) digital apparatus meets all the
requirements of the Canadian Interference-Causing
Equipment Regulations.
Cet appareil numérique de la Classe (A) respecte
toutes les exigences du Règlement sur le matériel
brouilleur du Canada.
Product warranty
This product is covered by a limited
warranty, details of which can be found at
www.johnsoncontrols.com/buildingswarranty.
Software terms
Use of the software that is in (or constitutes)
this product, or access to the cloud, or hosted
services applicable to this product, if any,
is subject to applicable terms set forth at
NAE55/NIE55 Installation Guide26
To Next Page
Loading...
Need help?
General
