CKM-CE75-E1M Introduction
24-10707-112 Rev. D
1-3
• SureCharge®
The microprocessor-controlled charging process used by FlexPower
guarantees the proper charging current for the battery and the fastest charge
time. The constant current charger provides a linear, predictable charge
time for any battery set from one at 40 ampere/hours to four at 40 ampere/
hours, depending on the model, without stress or damage to the battery.
• DataLink®
Smart power management communication interface. Program, monitor,
control and report key power supply functions by computer or over a local
or wide area network using a browser interface or LifeSafety Power’s
Remote Management Software.
DataLink computer connectivity requires an optional DL1 USB cable.
DataLink WAN/LAN connectivity requires an optional NL1 network
module.
• PowerCom®
The PowerCom power management software monitors, programs, and
reports on the power supply core functions through a computer or network
connection. See the PowerCom manual for complete details on
FlexPower’s power management capabilities.
• FlexConnect®
The FlexPower series provides a pre-wired interconnection system between
the power supplies and accessory boards of the power system that
eliminates inter-module wiring by the field installer. Field upgrading uses
common mounting footprints, predrilled mounting holes, snap-in standoffs,
and pluggable wires to add additional system capability or capacity when
needed.
• Reliability+®
All power supplies within the FlexPower system are fully fault protected.
• GreenSmart®
All members of the FlexPower family are RoHS compliant, lead-free, and
meet the latest federal and European requirements for energy efficiency.
To Next Page
Loading...
