3.3.2 Settings menu
The table below details the Settings menu.
Power status
Fully charged PEDs can be expected to last for more than 300 hours in normal
operating conditions before recharging is required. A low battery warning is
displayed when only eight hours is remaining.
Monitor details
The monitor details screen shows various useful pieces of information about the Tracerco PED and its
status. Calibration contact details can also be found here.
Time zone
Sets the local time zone to the display to show the local current time.
The time zone for the PED data is set on DoseVision™. Therefore, to ensure that the dose history data
is secure, you cannot change the time and date stored on the PED.
Language
Sets the locale of the displayed text.
Activity sounder
If enabled, the PED produces approximately 12 audible ‘clicks’ for a typical background radiation of
around 12 counts per minute.
You can configure the number of audible clicks for the radioactive particle detected. For example,
selecting divide by one (÷ 1) generates an audible click for each radioactive particle detected and
selecting divide by 30 (÷ 30) generates audible click every 2.5 minutes for a typical background
radiation.
Display type select
Sets the display to combined, dose rate only, or dose only mode.
Reset logs (if enabled in DoseVision™)
Clears logs from the memory.
Bluetooth and GPS (PED+ and PED-ER+)
• If Bluetooth is enabled, the PED can connect the DoseVision™ Live app (Android only).
• If GPS is enabled and a location lock has been achieved, location data will be logged every time
dose data is logged.
To Next Page
Loading...
Need help?
General
