©2017 Johnson Level & Tool - Rev. 1 11
2. While holding the laser by the hand grips, insert the horizontal vial
adjustment knob into the adjustment knob receiver.
3. Gently press the leveling base connecting bar
receiver into the laser’s connecting bar until
the clip spring is activated.
4. Place the leveling base with attached laser on a
relatively smooth, flat and level surface.
5. Turn the adjustment knob to center
the bubble in the vial.
Bubble Centered
Notes:
• While the laser is in the horizontal status (manual mode), set the
lock knob to the “Off” position.
• After operating or before moving the unit, always power off the
laser and set the lock knob to the “Off” position. This ensures no
damage can happen to the laser assembly during transport.
• If you plan to store the laser for more than 3 months, remove
batteries from the laser and detector.
1658i-English_Manuals 1/11/17 11:50 AM Page 11
To Next Page
Loading...
