Caution
Do not install the unit in a place where there is a chance of flammable gas leaks.
If there is a gas leak and gas accumulates in the area surrounding the unit, it could
cause an explosion.
Perform the drainage/piping work according to the installation instruction.
If there is a defect in the drainage/piping work, water could leak from the unit and
household goods could get wet and be damaged.
Do not clean the unit when the power is ‘ON’.
Always shut ‘OFF’ the power when cleaning or servicing the unit. If not, it could cause
an injury due to the high speed running fan or an electrical shock.
Do not continue to run the unit when there is something wrong or there is a strange
smell.
The power supply needs to be shut ‘OFF’ to stop the unit; otherwise this may cause an
electrical shock or fire.
Do not put your fingers or others into the fan, or evaporator.
The inside parts of the heat pump may run at high speed or high temperature, they
could cause serious injury. Do not remove the grills on the fan outlet and top cover.
The hot water will probably need to be mixed with cold water for terminal usage, too
hot water (over 50℃) in the heating unit may cause injury.
The installation height of power supply should be over 1.8m, if any water may spatter,
the unit can be safe from water.
To Next Page
Loading...
Need help?
General