INSTALLATION
Asked your supplier to install the unit. Incomplete installation performed
by yourself may result in a water leakage, electric shock, or fire.
Indoor installation is highly recommended. It is not allowed to install the
unit at outdoor or rain achieving place.
The installation place without direct sunlight and other heat supplies is
recommended. If no way to avoid these, please install a covering.
The unit must be securely fixed to avoid noise and shaking.
Make sure that there’s no remora around the unit.
In the place where there is strong wind, fix the unit in the location pro-
tected from the wind.
Transportation
As a rule, the unit is to be stored and/or transported in its shipping container in upright
position and without water charge. For a transport over short distance (provided that it
is done with care), an inclination angle up to 30 degrees is permitted, both during
transport and storage. Ambient temperatures of –20 to +70 degrees Celsius are per-
mitted.
- Transport using a forklift
When transported by a forklift, the unit must remain mounted on the pallet. The lifting
rate should be kept to a minimum. Due to its top-heaviness, the unit must be secured
against tipping over.
To prevent any damage, the unit must be placed on a level surface.
- Manual transport
For the manual transport, a wooden/plastic pallet can be used. Using ropes or carrying
straps, a second or third handling configuration is possible. With this type of handling,
it is advised that the maximum permissible inclination angle of 45 degree is not ex-
ceeded. If transport in an inclined position cannot be avoided, the unit should be taken
into operation one hour after it has been moved into final position.
To Next Page
Loading...
Need help?
General