Johnson MC-J6900 - Chapter 2:Maintenance And Storage

4
CHAPTER 2:MAINTENANCE AND STORAGE
To keep the appliance working and looking its best, please follow these cleaning guidelines
once a week.
Area covered with synthetic leather:
For cleaning, wipe the unit with a dry cloth moistened in diluted neutral detergent and
thoroughly wrung out. and then use a dry cloth to wipe the unit again. Thereafter, allow the unit to
dry naturally.
(Excessive use of detergent may harm the synthetic leather surface).
Keep the unit clean and place it in a location with appropriate temperature and avoid moisture
and dust.
 Prior to the maintenance work, make sure to disconnect the power cord. Be careful that hands
must not be wet to prevent electric shock or injury.
 Do not use benzene, thinner or alcohol to clean the choir, nor spray any liquid containing any
chemical agents to prevent the risk of electric shock or catching fire.
Main body:
Use a dry cloth moistened with diluted neutral detergent and thoroughly wrung out to clean the
plastics or the pipes, and then wipe with a dry cloth to completely remove the residual detergent.
 Wipe the coated surface with a dry cloth.
 Do not use benzene, thinner, alcohol solvents or abrasives to avoid scratch, discoloration or
cracks on the surface.
Remote controller:
Use a dry cloth to clean the remote controller.
 Never use a wet cloth for cleaning to avoid malfunction.
Back pad,pillow,seat cushion and other fabric parts:
Wipe the parts with a dry cloth moistened in diluted neutral detergent and thoroughly wrung out,
and then use a dry cloth to wipe the parts again. Thereafter, allow the parts to dry naturally.
 Do not iron to prevent damage to the fabric.
 Do not use benzene, thinner, or alcohol for cleaning, nor spray any liquid containing any
chemical agents to prevent damage to the fabric.
Storage:
After cleaning, keep the unit away from humidity. When the unit is not being used for a long
period of time, place a cover over the unit to protect it from dust.
 Do not place the unit in areas exposed to direct sunlight, or near heaters, hot air blowers or any
other heating devices to avoid discoloration or deterioration on the surface of the holster.