JOHNSON TREADMILL T8000/T8000 PRO JOHNSON TREADMILL T8000/T8000 PRO
Repeat the adjustments until the belt appears centered. Allow the treadmill to continue
running for several minutes at 6.4 km/h (4.0 mph) to be sure that the tracking is
stabilized.
NOTE: DO NOT exceed one full turn of the adjusting screws in either direction. If after
one full turn the belt does not track properly, please contact Johnson Fitness or the
local authorized dealers.
TENSIONING THE BELT
Check the tension of the belt. The belt should be very snug. When a person walks or
runs on the belt, it should not hesitate or slip. If this occurs, turn the belt tensioning
bolts a 1/4 turn clockwise for each side. Repeat if necessary until the belt no longer
slips. DO NOT exceed one full turn (i.e. four 1/4 turns) per side when adjusting the belt
tensioning bolts. If after tension the belt, the belt still hesitates or slips, please contact
Johnson Fitness or the local authorized dealers at once.
4342
If the belt has moved to the left, turn the left tension bolt a 1/4 turn clockwise and then
turn the right tension bolt a 1/4 turn counter-clockwise to start the belt tracking back to
the centre of the roller.
1/4 TURN
1/4 TURN
NOTE: DO NOT over-tighten the tensioning bolts while making belt adjustments.
Over-tightening of bolts may over stretch and damage the striding belt or roller
bearings. DO NOT exceed one full turn of either bolt in either direction.
MAINTENANCE LAMP
1/4 TURN
1/4 TURN
AND
There is a maintenance lamp on the console to remind the owner to do the scheduled
maintenance. When the treadmill’s accumulated distance reaches 4000 kilometers /
2500 miles, or the unit’s accumulated time reaches 6000 hours, the maintenance lamp
will light meaning maintenance is needed. The following is the maintenance lamp key:
• Still Blue Light: When the treadmill’s accumulated distance reaches 4000 kilometers
/ 2500 miles, it means that the treadmill needs to be maintained. To turn off the
maintenance light after performing service, hold the INCLINE and SPEED keys
at the same time for 3 seconds.
• Flashing Blue Light: When the treadmill’s accumulated time reaches 6000 hours, it
means that the treadmill’s running deck needs to be flipped. Every 12000 hours, the
running deck needs to be replaced. After the deck is flipped or replaced, turning off
the light to hold the INCLINE and SPEED keys at the same time for 3 seconds.
• Still Red Light: It means that the treadmill might have a problem, and needs to be
checked. Please contact Johnson Fitness customer service or local authorized dealers.
To Next Page
Loading...
Need help?
General
