15
Use Rain Cover
To assemble the rain cover, place it over the stroller, and then attach the 8 pairs of hook and loop fasteners on the
rain cover.
28
! Before using the rain cover, please make sure the backrest has been adjusted to the lowest position and the
infant car seat has been fastened.
! When using the rain cover, please always check its ventilation.
! When not in use, please check that the rain cover has been cleaned and dried before folding.
! Do not fold the stroller after assembling the rain cover.
! Do not place your child into the stroller assembled with rain cover during hot weather.
Use with Car Seat
see images
29
-
34
Use this car seat adapter only with the Litetrax Stroller and approved Joie Gemm and Nuna Pipa car seats.
! If you have any problems about using the car seat, please refer to their own instruction manuals.
! Please do not fold the stroller when the car seat is still attached.
Care and Maintenance
! Removable seat pad may be washed in cold water and drip-dried. No bleach.
! To clean stroller frame, use only household soap and warm water. No bleach or detergent.
! From time to time, check your stroller for loose screws, worn parts,torn material or stitching. Replace or repair
the parts as needed.
! Excessive exposure to sun or heat could cause fading or warping of parts.
! If stroller becomes wet, open hood and allow to dry thoroughly before storing.
! If wheels squeak, use a light oil (e.g., Silicon Spray, antirust oil, or sewing machine oil). It is important to get the
oil into the axle and wheel assembly.
24
! When using your stroller at the beach, completely clean your stroller after use to remove sand and salt from
mechanisms and wheel assemblies.
To Next Page
Loading...
Need help?
General
