42
FORWARD FACING MODE
41
The assembled safety belt is shown as Fig. 42
!
Shoulder belt passes through Lock-off Device, confirm the Lock-off
Device is pushed down, as Fig. 42.1
!
Waist belt passes through the forward safety-belt slots, as Fig. 42.2
!
The vehicle buckle tongue is engaged with the buckle correctly,
as Fig. 42.3
v. Securing your Child in the child restraint
1. Pull up the webbing adjuster, while pulling the shoulder harnesses to
proper length. (Fig. 12)
Fig. 12.1 Webbing adjuster
2. Press the red button to disengage the buckle (Fig 13.1), and then leave
the harnesses on the left side and right side of the seat. (Fig. 13.2)
3. Place the child in the child restraint and pass both arms through the
harnesses. (Fig. 43)
!
After the child is seated, recheck whether the shoulder harnesses are
at proper height, please refer to P. 39 (Proper Position of the Shoulder
Harnesses) & P. 40 (Shoulder Harnesses Height Adjustment). (Fig. 14)
4. Pull down the adjustment webbing and adjust it to the proper length so
that your child is snugly secured. (Fig. 44)
!
Make sure the space between the child and the shoulder harness is
about the thickness of one hand.
1. When installing the child restraint in the forward facing mode, DO NOT
use the small seat pad.
2. Please install the child restraint on the vehicle seat, and then put the
child in the child restraint.
3. After the child is placed into the child restraint, check whether the
shoulder harnesses are at proper height, please refer to P. 39 (Proper
Position of the Shoulder Harnesses) & P. 40 (Shoulder Harnesses Height
Adjustment).
Note
Cleaning Method
!
After removing the foam of small seat pad, please store it somewhere that
the child can not access it.
!
Please wash the soft goods with cold water under 30°C.
!
Do not iron the soft goods.
!
Do not bleach or dry clean the soft goods.
!
Do not use undiluted neutral detergent, gasoline or other organic solvent to
wash the child restraint. It may cause damage to the child restraint.
!
Do not twist the soft goods to dry with great force. It may leave the soft
goods with wrinkles.
!
Please hang dry the soft goods in the shade.
!
Please remove the child restraint from the vehicle seat if not in use for a
long period of time. Put the child restraint in the shade and somewhere your
child can not access it.
Detach Soft Goods
1. Take off shoulder harnesses from T shaped piece to remove shoulder
harnesses. Refer to P. 39 (Disassembly of the Shoulder Harnesses).
2. Press the buckle, then remove the small seat pad. (Fig. 45)
3. Remove the fastening pieces on sides of the seat pad from the two slots
on both sides of the body. (Fig. 46)
4. Remove the fastening pieces in front of the seat pad from the two slots on
the bottom of the body. (Fig. 47)
5. Thread the adjustment webbing and harnesses on both sides out from the
seat pad. (Fig. 48)
6. To remove the crotch strap cover, first locate the elastic on the inside of the
crotch strap cover. Pull both the elastic and the crotch strap cover over the
buckle to remove. (Fig. 48)
7. Thread the buckle out from seat pad slot for crotch strap to remove the
seat pad. (Fig. 49)
To assemble soft goods in reverse steps. (Fig. 50)
To Next Page
