USER MANUAL
19
STEP 3
Swipe the RFID Card:
Swipe the RFID card first and plug in the charging connector within
120 seconds, otherwise you need to swipe the RFID card again.
STEP 4
Charging: The green light (CHARGE) turns
to flash automatically, charging is in process.
If the red light (FAULT) is on, plug in the charging
connector again.
If red light is still on, please refer to "Error
and Warning Messages".
STEP 5
Charging finished:
When the charging is finished or swipe your
RFID card, the green light (CHARGE) is
constantly on. Please press the button on
connector and pull out the charging connector
To Next Page
Loading...