1.4 Controller BP07 use
10
Operation status
Press the button to go from Summer status to Winter and vice versa:
Summer 왘 Winter 왘 Summer
Operation programme
—- —- —- —- —- SUMMER —- —- —- —- —-
OF LX (1-9) OF
OFF 왘 Manual 왘 OFF
—- —- —- —- —- WINTER —- —- —- —- —-
OF LX(1-9) AU OF
OFF 왘 Manual 왘 Automatic 왘 OFF
Press the button to go from one operation programme to another :
Setting the required ventilation level
In Manual the set ventilation level LX will appear on the right on the display, where X can assume values of 1 to 9.
Use the buttons .to modify the set value X.
Display of ventilation level in automatic (with remote control only)
Press the button for 3 seconds to display the current ventilation level (which can momentarily differ from that set, for example in
automatic). The ventilation level LX will appear in the middle of the display, where X can assume values of 1 to 9.
To return to normal operation just press the button again or wait 60 seconds without pressing other buttons.
Dissipation programme
If the fireplace reaches excessive temperatures a programme called Dissipation will be automatically activated (with probe only) and
signalled with the message Ht (High Temperature). This programme has priority over all the other settings, which will possibly be ignored.
NOTE!
When the contact thermostat is present on the fireplace, the fan speed “Automatic” function is not present.
To Next Page
Loading...
Need help?
General