Joni MultiMix - Page 42

we know what‘s cooking
41/69
Document 10000028013-DOC-000-00-EN
Program 13
This program adds water to the kettle and starts the heating and stirrer at a set time. When the required
temperature has been reached, the temperature set point, heating power, stirring pattern and RPM are
altered. After the required period of time, the temperature set point, heating power, stirring pattern and
RPM are altered again. This could be used, for example, to automatically start heating up, cooking fol-
lowed by warm-keeping.
7 Set stirring pattern and stirring RPM
Switch on the stirrer
P07.1 Stirring pattern
P07.2 Stirring rate
If stirring pattern 0 is selected, this
step will be skipped.
8 Pause for required time P08.1 Time
9 Set the set point for food temperature and heating
power
P9.1 Food temperature
P9.2 Heating power
10 Set stirring pattern and stirring RPM
Switch on the stirrer
P010.1 Stirring pattern
P010.2 Stirring rate
If stirring pattern 0 is selected, this
step will be skipped.
11 Pause for required time P011.1 Time
12 Activate beeper
Step Action Parameter
1 Switch to heating mode
2 Pause for required time P02.1 Time
3 Add water in required quantity P03.1 Water quantity
4 Set the set point for food temperature and heating
power
P04.1 Food temperature
P04.4 Heating power
5 Switch on heating
6 Set stirring pattern and stirring RPM
Switch on the stirrer
P06.1 Stirring pattern
P06.2 Stirring rate
If stirring pattern 0 is selected, this
step will be skipped..
7 Pause until the set point for food temperature has
been reached
8 Set the set point for food temperature and heating
power
P08.1 Food temperature
P08.2 Heating power
9 Set stirring pattern and stirring RPM
Switch on the stirrer
P09.1 Stirring pattern
P09.2 Stirring rate
If stirring pattern 0 is selected, this
step will be skipped..
10 Pause for required time P010.1 Time
11 Set the set point for food temperature and heating
power
P11.1 Food temperature
P11.2 Heating power
12 Set stirring pattern and stirring RPM
Switch on the stirrer
P012.1 Stirring pattern
P012.2 Stirring rate
If stirring pattern 0 is selected, this
step will be skipped..
13 Pause for required time P013.1 Time