CONTENTS
Contents
KEY TO SYMBOLS
Symbols ......................... 2
CONTENTS
Contents ........................ 3
Note the following before starting .... 3
WHAT IS WHAT?
What is what? ................... 4
GENERAL SAFETY PRECAUTIONS
Important ........................ 5
Personal protective equipment ...... 5
Machine's safety equipment ........ 6
Cutting equipment ................. 8
ASSEMBLY
Fitting the handlebar ............... 10
Fitting the harness and harness clamp 10
Fitting blades and trimmer heads .... 11
Fitting a blade guard, grass blade and
grass cutter ...................... 11
Fitting the trimmer guard and
trimmer head ..................... 12
FUEL HANDLING
Fuel safety ....................... 13
Fuel ............................ 13
Fuelling ......................... 14
STARTING AND STOPPING
Check before starting .............. t 5
Starting and stopping .............. 15
WORKING TECHNIQUES
General working instructions ........ 17
MAINTENANCE
Carburetor ....................... 20
Muffler .......................... 20
Spark plug ....................... 21
Air filter .......................... 21
Bevel gear ....................... 22
Sharpening grass cutters and grass
blades .......................... 22
Maintenance schedule ............. 23
TECHNICAL DATA
Technical data .................... 24
EMISSION CONTROL
WARRANTY STATEMENT ......... 25
Note the following before
starting:
Please read the operator's manual carefully.
Maintenance, replacement, or repair of the
emission control devices and system may
be performed by any nonroad engine repair
establishment or individual,
Jonsered has a policy of continuous product
development and therefore reserves the right
to modify the design and appearance of prod-
ucts without prior notice.
_ WARNING: Long-term exposure
to noise can result in permanent I
hearing impairment. Always use ap-
proved hearing protection.
The Emissions Compliance Period referred
to on the Emissions Compliance label indi-
cates the number of operating hours for
which the engine has been shown to meet
Federal emissions requirements,
Category C = 50 hours, B= 125 hours, and
A = 300 hours.
4t I 61 I 81 I
WARNING
Theengine exhaustfromthisproduct
contains chemicalsknownto the State
of California to causecancer,birth
defects or other reproductiveharm.
For reference, please fill out the following
information that will be needed for future
servicing of your trimmer:
Model Number:
Serial Number:
Purchase Date:
Purchased From:
&
&
WARNING: A clearingsaw,
brushcutter or trimmer can be
dangerous if used incorrectly or
carelessly, and can cause serious
or fatal injury to the operator or
others. It is extremely important
that you read and understand the
contents of this operator's manual.
WARNING: Under no circum-
stances may the design of the
machine be modified without the
permission of the manufacturer.
Always use genuine accessories.
Non-authorized modifications
and/or accessories can result
in serious personal injury or the
death of the operator or others.
Your warranty may not cover
damage or liability caused by the
use of non-authorized accesso-
ries or replacement parts.
To Next Page
Loading...
Need help?
General
