Jonsered FR 2312 M - Engine Starting Variations; Starting with a Weak Battery

English – 15
Driving
FR2312 M has the brake pedal and lock button on the right
hand side. The engine can not be started if the parking brake
is not pressed down.
4 For FR2312 M
Put the gear shift lever in the ”N” position (neutral).
With a cold engine:
5 Move the throttle to position 3 (choke position). In this
position the engine is fed with a richer mixture, which
means the engine is easier to start.
With a warm engine:
6 Move the throttle in between positions 1 and 2.
7 Turn the ignition key to the start position.
8 When the engine starts release the ignition key
immediately back to neutral position.
9 Move the choke lever gradually back once the engine has
started. Let the engine run at moderate speed or half
throttle for 3-5 minutes before subjecting it to heavy load.
10 Set the required engine speed with the throttle control.
Starting the engine with a weak
battery
If the battery is too weak to start the engine, it should be
recharged. Charge the battery for 4 hours at max. 3 amp.
When the battery is fully charged, connect the red cable to the
positive pole (+pole) of the battery and the black cable to the
negative pole (-pole). Ensure that the red (+) cable is drawn
behind the black (-) cable.
When jump leads are used for emergency starting, follow the
procedure below:
IMPORTANT INFORMATION
If the engine does not start, wait about 15 seconds before
trying again. If the engine does not start wait about 1 minute
before trying again.
1
3
2
3
1
2
!
WARNING! Never run the engine indoors, in
enclosed or poorly ventilated areas. The
exhaust fumes contain toxic carbon
monoxide.
IMPORTANT INFORMATION Your Rider is equipped with a
12-volt system with negative earth. The other vehicle must
also have a 12-volt system with negative earth. Do not use
your Rider battery to start other vehicles.