English – 19
Driving
Stop the engine
Preferably allow the engine to idle for a minute to obtain
normal working temperature before stopping it if it has been
working hard.
1 Lift up the cutting unit by pulling the lever backwards to its
locked position.
1 Pull back the throttle and turn the ignition key to the
”STOP” position.
2 When the Rider is at a standstill, press down the parking
brake and push in the locking button.
Release lever
The release control must be pulled out in order for the
machine to be moved when the engine is shutoff.
Pull the controls to the end positions, do not use an
intermediate position.
Clutch control, rear axle
• Control drawn out, drive system disengaged.
• Control depressed, drive system engaged.
Clutch control, front axle
The control is positioned on the inside of the left front wheel.
• Rear control (pulled out), drive system disengaged.
• Front control (pushed in), drive system engaged.
STOP
START
To Next Page
Loading...
