English – 29
Maintenance
5 Lift off the drive belt and hang on the load-relieving hook.
6 Loosen on the cutting height stay and place in the holder.
7 Grip the front edge of the unit and pull forwards until it
stops.
8 Lift the unit until it stops and a clicking sound is heard.
9 The unit locks automatically in the vertical position.
Restoring from service position
1 Grip the front edge of the unit and loosen the lock, fold
down and slide in the unit.
2 Replace the cutting height stay and the belt. Tension the
belt with the belt adjuster.
3 Fit the front cover.
4 Set the cutting height control to one of the positions 1-7
Placing in the service position
Combi 103, Combi 112
1 Position the machine on flat ground. Apply the parking
brake. Adjust the cutting unit to the lowest cutting height
and lower the cutting unit.
2 Remove the front hood by removing the pin. (There are
complete instructions on using the service position inside
the front hood).
To Next Page
Loading...
