English – 13
SVENSKA
1
1
2
SVENSKA
3
Fuel handling
Start and stop
Cold engine
1. Push the short-circuiting
switch (1) to "ON"
(forwards).
2. Push the choke control
to closed position (2).
3. Press in the air purge(3)
3 – 4 times.
Varm engine
Use the same starting
procedure as for the cold
engine, but do not set the
choke control in the choke
position.
Start
Grip the starter handle and
slowly pull out the starter
cord until a resistance is felt
(starter prawl engages).
Now give a quick and strong
pull.
NOTE!
Do note pull the starter cord
out completely and do not
release the starter cord from
the fully extended position.
This can damage the
machine.
Move the choke control
back to the initial position
immediately when the
engine fires, and make
repeated attempts to start
until the engine starts.
Fuel handling – Start and stop
Fuelling
WARNING!
The following precautions reduce the
risk of fire:
Do not smoke or place any source of
heat in the vicinity of the fuel.
Never refuel when the engine is running.
Open the fuel cap slowly when fuelling
so that any over pressure is released
slowly.
Tighten the fuel cap carefully after
refuelling.
Always move the machine from the
fuelling place before starting.
WARNING!
• Always move the machine from the
filling position before starting.
• Place the hedge trimmers on a firm
surface and make sure that you
are standing in a well-balanced
position before starting the engine.
• Make sure that no unauthorised
persons are in the working area.
• Check before starting that the
clippers cannot bite into any
object.
WARNING!
Beware of the moving cutting blades
when the engine is started.
• Clean around the fuel
cap. Contamination in
the tank can disrupt
operations.
• Ensure that the fuel is
well mixed by shaking
the container before
filling the tank.
ENGLISH
To Next Page
Loading...
Need help?
General
