English – 7
SVENSKA
45°
6. Blade and hand guard
Sharpening of
the clippers
It is important that the
clippers are always sharp to
ensure full cutting capacity
and clean cuts.
Dismantle the blade guard
and use a plain file to
sharpen the teeth. The filing
angle should be 45°.
Safety instructions
WARNING!
Never use a machine with defective safety
equipment. The safety equipment should
be maintained as described in this section.
If your machine does not meet any of
these controls you should contact your
service workshop.
Check the clippers each time
they are used for:
• Damage and wear to the
the teeth.
• Wear on the blade’s
guide slots, screws and
washers.
• Warping of the blade.
• Oiling of the blade and
gear case.
See chapter ”Maintenance”
for appropriate measures.
Checking the clippers
WARNING!
Defective clippers can increase the risk of
accidents.
IMPORTANT INFORMATION
• The machine is only designed for cutting hed-
ges.
• The only accessories to be used with the engine
as a drive source are the cutting units we
recommend.
• Never use the machine if you are tired, if you
have consumed alcohol, or if you are taking
medicines that can affect your sight, your
judgement or the control of your body.
• Use personal safety equipment. See the section
"Personal safety equipment".
• Never use a machine that has been modified so
that it no longer corresponds with the original
design.
• Never use a machine that is faulty. Follow the
maintanence, control and service instructions
in this Operator's Manual.
Some maintenance and service actions should
be carried out by trained and qualified
specialists. See the chapter
"
Maintenance"..
• All covers and guards must be fitted before
starting the machine. Check that the spark plug
cap and HT lead are not damaged, otherwise
you could get an electric shock.
General safety instructions
Check that the blade guard
is secure and not damaged.
Check that the left and right
hand guard are in good
condition without visible
defects, e.g. cracking.
ENGLISH