To Next PageTo Next Page
Need help?Do you have a question about the Jonsered LT 2317 A and is the answer not in the manual?
General| Cutting Width | 97 cm |
|---|---|
| Cutting Height Adjustment | Central |
| Engine Manufacturer | Briggs & Stratton |
| Engine Net Power | 8.6 kW |
| Transmission Type | Automatic |
| Displacement | 500 cm³ |
| Cutting Height Range | 38 - 102 mm |
Read instructions, be familiar with controls and proper use of equipment. Never allow children or unfamiliar persons to use.
Reduce fire risk by inspecting and removing debris before use, during refueling, and at end of session.
Do not operate in confined spaces, mow only in daylight or good light, disengage blade clutches before starting.
Keep nuts/bolts tight, never store with fuel indoors, allow engine to cool, keep areas free of grass/grease.
Parts enclosed for transportation must be assembled before use, including steering wheel, seat, and battery.
Mount extension shaft, main shaft cover, and steering wheel. Ensure wheels are aligned forward.
Install seat onto pan, ensuring correct alignment. Adjust seat for comfortable position and pedal access.
Connect battery terminals correctly. Charge battery if necessary. Follow safety precautions before installation.
Identifies and describes the location and function of key controls like light switch, throttle, brake, ignition, and levers.
Details the steps for starting the engine, including using the choke, ignition key, and throttle control.
Use unleaded petrol, fill outdoors, do not smoke, do not overfill, check tank and pipes for leaks.
Check engine oil level with tractor horizontal. Use SAE 30 or SAE 5W-30 oil depending on temperature.
Regularly check tire pressure and ensure tires are properly inflated to the PSI shown on tires.
Press brake pedal, ensure motion control is in neutral, then start engine and engage drive.
Ensures operator presence and ROS function correctly. Engine shuts off if operator leaves seat with attachment engaged.
Disconnect spark plug wire, press brake pedal, engage parking brake, move controls to neutral, and switch off engine.
Steps for removing and installing the mower drive belt, including proper routing and tensioning.
Instructions for visually and precisely adjusting the mower deck side-to-side and front-to-back for optimal cutting.
Describes using the deck washout port for cleaning the mower deck. Ensure proper connection and safety.
Troubleshooting steps for when the engine will not start or the starter motor will not turn the engine.
Diagnosing and resolving issues like uneven running, weak power, overheating, and battery not charging.
Addresses causes of machine vibration, uneven cutting results, and cutting problems.
Steps for preparing the tractor for storage, including cleaning, oil change, fuel draining, and battery care.
Information required when ordering spare parts, including model, serial number, and purchase date.
