To Next PageTo Next Page
Need help?Do you have a question about the Jonsered LT2113 and is the answer not in the manual?
General| Engine Manufacturer | Briggs & Stratton |
|---|---|
| Engine Displacement | 344 cc |
| Transmission Type | Manual |
| Number of Gears Reverse | 1 |
| Cutting Height | 1.5 - 4 inches |
Operator training and instruction emphasis.
Pre-operation checks, fuel handling, and area inspection.
Safe operating practices for slopes, loads, and general use.
Procedures for maintaining and storing the tractor.
Instructions for mounting the steering wheel.
Instructions for installing and adjusting the tractor seat.
Warnings and procedures for safe battery connection.
Identifies and explains the location of tractor controls.
Instructions for safely filling the fuel tank.
How to check and maintain the engine oil level.
Recommended tire inflation pressures for optimal performance.
Steps to start the tractor engine safely.
How to operate the tractor, including cutting unit and speed selection.
How to use the system for operating in reverse with attachment engaged.
Advice for optimal cutting results and lawn care.
Safety precautions and guidelines for driving on inclines.
Procedure for safely stopping the tractor engine.
Steps to take before performing engine or cutting unit maintenance.
Instructions for removing and reinstalling the engine hood.
Guidelines for regular maintenance tasks based on usage hours.
Step-by-step guide for draining and refilling engine oil.
Log for service completion dates and maintenance intervals.
Verify the tractor's safety system that detects operator presence.
Verify the safety system for operating in reverse.
Importance of sharp blades and how to replace them.
Steps to remove and install mower blades.
Procedure to test the tractor's braking system.
Step-by-step instructions for removing the cutting unit.
Step-by-step instructions for installing the cutting unit.
Instructions for removing and installing the cutting unit drive belt.
How to adjust the cutting unit for optimal cutting results.
How to adjust the cutting unit's levelness side-to-side.
How to adjust the gear shift lever for neutral position.
Common causes and solutions for engine starting failures.
Troubleshooting steps when the starter motor does not engage.
Diagnosing and fixing issues causing uneven engine operation.
Troubleshooting poor engine performance.
Identifying and resolving causes of engine overheating.
Diagnosing and fixing battery charging problems.
Troubleshooting issues with the tractor's lights.
Identifying and fixing causes of excessive machine vibration.
Troubleshooting poor lawn cutting quality.
Steps to prepare the tractor for seasonal storage.
