Jorvik Elite JET-E2 - Brake Lever Adjustment and Bed-in Procedure

Jorvik JET-E2 Elite Mid-Drive Dual Battery Electric Folding Tricycle
18
How To Assemble This Tricycle
Assembly Instructions
Make sure that the brake lever does not contact the
handlebar when full hand pressure is applied. The contact
point should feel rm and solid. If the lever travels all the
way to the handlebar or feels spongy, they may require
service by a qualied bicycle technician.
If the brakes are still not operating correctly, they may
require further adjustment by an experienced bicycle
mechanic.
New Brakes Bed-in Procedure
New brakes will require a “bed-in” procedure prior to
your rst ride, which will ensure the most consistent and
powerful braking feel.
1. Find a safe riding area that will allow for moderate
speed. Remain seated during the entire procedure for
optimal results.
2. Accelerate the trike to a moderate speed, then rmly
squeeze the brake levers until you are at walking
speed. Repeat this process about twenty times.
3. Accelerate the trike to a faster speed, then rmly
squeeze the brake levers until you are at walking
speed. Repeat this process about ten times.
IMPORTANT NOTE:
Do not lock up the wheels at any point during the bed-in
procedure.