Jorvik JMT6 Low Step Through Electric Mountain Trike
18
How To Assemble This Tricycle
The keys are used to lock the battery into place. Always
make sure that the key position is in the “unlock” position
when removing or inserting the battery. Move the key to
the “on” position to secure the battery before operating the
trike. Riding the trike with the key is in the “unlock” position
risks allowing the battery to slide out and damage the
battery when dropped. Always remove the battery from
the trike when transporting on a trike rack.
After receiving your E-trike, please keep the keys
separately, in case of losing both keys, Jorvik tricycles Ltd
is not able to deliver replacements.
Appearance Care And Maintenance
Periodically clean your Jorvik tricycle electric trike with a
damp cloth. Avoid spraying the bike with a water hose to
avoid electrical issues. Store your bike in a dry shelter area
away from direct sunlight and wet or damp environments.
It is also recommended to apply chain lube to the
drivetrain of your trike when you clean it or wipe it down to
keep it in good running condition.
Monthly, clean your drivetrain and inspect chain for wear;
re-apply lubricant to the chain and wipe off any excess
with a cloth. Check wheels for loose spokes; tighten if
necessary. Check the tightness of stationery and moving
parts, such as, the crank arms and pedals, stem bolts, axle
nuts, etc. Inspect your braking system, both levers and
callipers to ensure safety while riding. Replace damaged
or worn parts, such as, cables and brake pads
Battery Fuse
The fuse is designed to protect the battery. If the fuse
blows, there will be no power to any of the electrical
components powered by the battery.
You can email Jorvik Tricycles for further advice if required.
info@jorviktricycles.com
Tyres And Inner Tubes
Use a reliable tyre air pressure gauge to check for ination
before every ride. At the same time, inspect tyres for
excessive wear and cracks. Replace tyres if necessary.
To Next Page
Loading...
