jotron TA-7650C - Page 47

Jotron AS| TR7750C: Operators Manual  Installation
Page 4-19
P/N: 84748 (G)
Table 4.7-2, Transceiver, Remote (2W) interface
Figure 4.7-3, Transceiver, Remote configuration with 4 wire audio interface
Step
Description
Reference
1
For audio line interfaces refer to the reference
4.6.2 – Audio interface
3
Set Audio output source to Lineout (receiver)
5.9.2 - RX config group
4
Set Audio input source to line (transmitter)
5.5.2 – TX config group
5
Set Keying source to include txkeygnd ( or other signal if
desired)
5.5.2 – TX config group
6
Connect a coax cable (RG58 or better) between the TA – Receiver
antenna connector (BNC) and the antenna input on the receiver.
Alternatively, use separate antennas for the TA and RA.
3.2.2 and 3.4.1