15
Jøtul F 370 U.S. 10036803_P12
Figure 18. Install the cast iron burn plates.
5.8 Final Assembly
1. Replace the Ash Pan within the ash pan compartment.
2. Replace the Bottom Plate and Shaker Grate in the
stove bottom.
3. Replace the Rear and Side skamol panels.
4. Place the two cast iron Burn Plates into position under
the side windows. Fig. 18, A.
5. Replace the Smoke Baffle/Manifold in position in the
upper firebox. It rests upon the side and rear skamol
panels.
5.7 Secure the stove to the hearth
1. At the anchor bracket hole, drill a 1/4” dia. pilot hole
through the hearth and into the floor material.
NOTE: For masonry floor materials, install a 3/8” dia.
lead bolt anchor or shield into the floor.
2. Open the pilot hole in the hearth material to 3/8”
diameter to avoid cracking.
3. Secure the pedestal base to the hearth using the
supplied 2 1/2” lag bolt and 9/16” socket wrench.
4. Replace the anchor cover plate and secure it with the
two acorn nuts supplied with the anchor bracket.
To Next Page