20
5.4 Anti-tip wheel
The anti-tip wheel assembly is installed on the back of the scooter frame
for your safety. It prevents the scooter from tipping backwards when you drive
over obstacles that do not exceed the specified maximum height.
5.5 Transfer in or out the scooter
WARNING! Be sure to turn off the power switch and remove the key
before getting on or off the scooter.
5.6 Correct position in scooter
Here is some advice for comfortably using a scooter:
5.6.1 Sit with your back as close to the backrest as possible.
5.6.2 Make sure your thighs are level as you sit.
5.7 Driving
5.7.1 Start and drive
5.7.1.1 Check that the manual freewheel lever is closed.
5.7.1.2 Turn the power key switch to the "ON" position first.
5.7.1.3 Check the battery gauge to confirm the amount of remaining power in
the battery, and charge the battery when it is low.
5.7.1.4 Adjust the speed knob to the desired speed.
5.7.1.5 Check out and confirm the safety of the surrounding environment and
road conditions.
5.7.1.6 The operation of throttle control lever
Slowly turn the right throttle control lever to control the front of the scooter,
and turn the left throttle control lever to control the back of the scooter. [NOT
SURE ABOUT THIS FRONT AND BACK. COULD MEAN FORWARD MOTION AND
REVERSE? WHICH? ALSO END OF NEXT SENTENCE?] Adjust the speed of the
scooter according to the forward and backward degree of the throttle
control lever.
5.7.1.7 Moving forward: Hold the straight handle, push the right throttle control
lever forward with the right thumb, and the scooter will move forward.
5.7.1.8 Moving in reverse: Hold the straight handle, push the left throttle control
lever forward with the left thumb, and the scooter will move backward. The
horn will sound a warning sound when the scooter is moving in reverse.
USE
To Next Page
Loading...
Need help?
General
