JR PCM9X II Programming

www.modelflight.com.au – World’s best source of JR products
Step #21 Flap Ra
t
e, Flape
r
on Mix and Fli
g
ht Mode Dela
y
Many pilots prefer to have variable camber adjustment
during launch. This enables adjustments to be made at
the last minute or even during launch, based on wind
and winch conditions.
I m po r t a n t : The flaperon and elevator values in the
camber mix menu are based on a percentage of the
programmed
flap rate. The flap rates are
Flap Rate
In FUNC. L IST rotate the Selector until F L A P R A TE i
s
highlighted. Press the Selector to access the Flap Rat
e
menu. Rotate the Selector to highlight the launch dow
n
value then press the Selector to access this value. Wit
h
the flight mode switch in the upper launch mode, mov
e
the left side lever to the lower most position and adjust
defaulted to 0% from the factory, so flaperon and
elevator mix values have no effect until the flap rate
values are set. Because of this, it‘s mandatory to first
adjust the flap rates before adjusting the flaperon
and elevator camber mixes. Also remember that
changing the flap rate values also affects the
flaperon and elevator camber mix.
the down value to the desired flap position. Now, with th
e
flight mode switch in the upper launch mode, move th
e
left side lever to the uppermost position and adjust the u
p
value to the desired flap position. Press the LIST butto
n
to return to the Function Mode screen.
Sail
p
lane P
r
o
g
r
ammin
g
Guide 14

JR PCM9X II Specifications

General

Brand	JR
Model	PCM9X II
Category	Receiver
Language	English