EasyManua.ls Logo

JRC JHS-183 - Specifications

JRC JHS-183
102 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CONFIGURATION AND SPECIFICATIONS
1-6
1.3 Specifications
1.3.1 JHS-183 Automatic Identification System
(1) General Specification
Frequency range 156.025MHz to 162.025MHz
Default channel AIS1: 161.975MHz, AIS2: 162.025MHz
Channel spacing 25kHz
Frequency accuracy
Within ±3×10
-6
Type of emission G1D (F1D), G2B (F2B)
Type of modulation GMSK, FSK
Output power 12.5W/1W
Type of display 4.5-inch FSTN LCD, 128 x 64dot
keyboard 12 keys
Back-light LCD and keyboard
Dimmer control Bright, Medium1, Medium2, Off
Compass safe distance NTE-183; Standard compass 0.4m, Steering compass 0.2m
NCM-983; Standard compass 0.5m, Steering compass 0.3m
NQE-5183; Standard compass 0.7m, Steering compass 0.5m
NBD-577C; Standard compass 0.8m, Steering compass 0.5m
Performance criteria
Power voltage Typ. 24VDC, 19 - 35VDC
Current consumption
24VDC Input
3.0A max. (when transmitting),
1.0A max. (when receiving)
Operating temperature range AIS transponder (NTE-183) -25°C to +55°C
AIS controller (NCM-983) -15°C to +55°C
Storage temperature range -15°C to +55°C (exposed equipment; -25°C to +70°C)
Humidity resistance No abnormality after standing 4 hours in +40°C, 93% RH
Vibration resistance (3 axes)
2 Hz - 5 Hz to 13.2 Hz: : Full amplitude ±1 mm±10%
13.2 Hz to 100 Hz: : Maximum acceleration 7 m/s
2
fixed
No abnormality after testing resonance points or at 30 Hz for more
than 2 hours
Protection rating AIS transponder (NTE-183): IP56
AIS controller (NCM-983): IP55 (In case optional cable is not used.)
Dimensions and mass
AIS transponder (NTE-183)
145mm(W) x 1270mm(H) x 145mm(D)
[including VHF antenna]
,
approximately 2.6kg
AIS controller (NCM-983)
142mm(W) x 142mm(H) x 115mm(D), approximately 2.1kg
(2) Communication ports
(2.1) Communication ports
The communication ports using the attached cable (CFQ-9183A) are as follows.
Sensor data input ports
SENSOR1 / SENSOR2
Two input ports meet the requirements of IEC 61162-1 and 61162-2
GNSS differential correction data
input port
ITU-R M.823-2 1port
External display equipment
communication ports (AUX)
IEC61162-2 1ports
Pilot plug IEC61162-2 1port
Network(LAN) IEC61162-450 1port

Table of Contents

Other manuals for JRC JHS-183