INSTALLATIONS
3-28
3.1.4.2 Connection method for power supply unit
1. Remove the screw and open the cover.
2. When using input voltage is 100VAC - 120VAC, connect the plug P1 to 100VAC - 120VAC connector.
3. Tighten the screw to fix the cover.
4. Remove four screws, connect the power source cables.
5. Tighten four screws to fix the cover.
6. Fix the upper cover and stick the label for the input voltage.
100VAC - 120VAC
200VAC - 240VAC (Initial setting)
Connect to NQE-5183 (DC IN)
C input
DC input
Cable cover screws
Terminal cover screws
To Next Page
Loading...