Chapter 2 OPERATIONS
2.9 RADAR ECHO SETTINGS
2-78
2.9.3 PROCESS
Process
This function reduces unnecessary noise to highlight targets.
Note:
When viewing a radar beacon, SART signal, or fast moving target on the radar
display, do not use this function.
This function is suitable for use in TM mode.
When used in RM mode, use with N Up or C Up. This can be used with H Up,
however, the video may be blurred. Use this in TM mode.
Reference:
The bearing data input is required for video processing.
1 Open RADAR Echo - Process .
"Process" menu appears.
Off : Select this mode in general.
3Scan COREL : Select this mode when many rain/snow clutter returns are
detected.
4Scan COREL : Select this mode to highlight targets while suppressing sea
clutter returns.
5Scan COREL : Select this mode to detect small targets hidden by sea clutter
returns.
Remain : Select this mode when own ship yaws wildly.
Peak Hold : Select this mode to detect small targets of which detection
probability is low.
To Next Page
Loading...
